Thread back to the bottom and the outside cover. Thread the cording back through the first hole, but into the middle of the second signature. Thread through the bottom hole back to the outside cover. Thread from the outside of the leather to the inside of one of your signatures. (see pattern for slits) Be sure to use a protective mat as you cut!Ĭut a length of cording about 18 – 24 inches long. On the end that sticks out a little extra, cut two slits about 1/2 an inch long and 1/4 an inch apart in the middle of that section. Most hole punches will go through leather no sweat. ![]() Mark that indent with your pencil or marker and punch. Pick up the pieces and feel for an indent of your paper holes. You should have some extra on the bottom. Line up the edge of the signatures and the edge of the leather up and wrap leather around. Use those holes as a guideline for punching the second set of holes.Ĭut out a piece of leather, felt or reinforced fabric to 5.5 inches x 11 inches. Just take the center page of your first punched signature and nest it into the second. Download printable dot grid, lined and blank sheets with these hole guidelines here. You’ll want to measure 1/2 – 3/4 of an inch in from each end and punch a hole along the fold. You can use a regular hole punch, but if you’re looking for an awesome punch and rivet/eyelet/snap setter all in one, you’ll want this one (c/o WRM, and I LOVE IT!!!). You will make 2 signatures with 8 sheets.įold your paper in half, creasing in the middle with your finger, then creasing outward from the middle with the bone folder.įold both signatures, now you’re ready for punching holes! Cut your paper in half so it measures 8 1/2 x 5 1/2 inches. If you want dot gridded paper, lined paper or blank paper with punch guides, download the free printable here. Read more to learn how to assembly this easy easy book!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |